Voltage Converter Stabilizer SilverCloud 2000VA 1200W, Black
£55.66
Price: £55.66
(as of Jun 16, 2025 13:22:30 UTC – Details)
From the brand
PNI Video Surveillance Systems
PNI Wireless Alarm Systems
PNI CB Radios
CB Radios and Accessories
Is discontinued by manufacturer : No
Product Dimensions : 23.7 x 17.9 x 14 cm; 6 kg
Date First Available : 7 Jun. 2017
Manufacturer : Silvercloud
ASIN : B071WRRZV9
Item model number : 3917
Country of origin : China
Guaranteed software updates until : unknown
The SilverCloud K2000VA automatic voltage stabilizer can be used to power electronic devices that consume up to 1200 W.
SilverCloud K2000VA is powered by a voltage that can vary between 140 and 260 V.
The output of the stabilizer is 220V constantly offered by 2 schuko sockets located on its rear panel.
The stabilizer is equipped with an output signal delay circuit that is recommended when using refrigeration equipment, to minimize the possibility of compressor motor failure.
The stabilizer is equipped with electrical circuits for protection against overvoltage (when the input exceeds the value of 255 V), for short circuit and overload.
![Tripods: The Complete Series 1 & 2 [DVD]](https://i2.wp.com/m.media-amazon.com/images/I/71WO69YKeiL._AC_SL1500_.jpg?w=300&resize=300,300&ssl=1)
Shaun H. –
A widely inaccurate and untrustworthy device
I bought this to stabilise the power for my valve/tube audio amplifier. The AC mains voltage round here has been 250 volts and the amp was designed for 230 volts.I noted the following problems:The device always reads 230 volts as output, even though its actual output is 220 volts and sometime less.The input voltage reading is also inaccurate showing about 10 volts less than the actual incoming mains voltage.The thing also suddenly started outputting 248 volts, the incoming mains voltage after running for a while. This caused my four output tube/valve anodes to seriously “red plate” as they had been setup to run at 220 volts. I measured the output at 248 volts at the time. The power being used by the amp was 250 watts, and the device should supply 1200 watts. I was horrified by this, because my amp could have been wrecked and so the stabilizer device was disconnected and a return arranged.Schuko to UK adapters were supplied. These were flimsy, and easily fell out of the sockets on the unit. A standard UK plug did not fit properly, leaving over a quarter of an inch of the pins visible.
Phil –
Not convinced it works
I bought this to smooth out the voltage from a portable generator. The display said 230v but I checked with a multimeter and it was going all over the place so I sent it back. Also I was puzzled how it managed to convert 160v input to 230v output. Maybe that is possible somehow but I was not convinced.
Jeepsey –
AVAOID THIS ITEM
This item does not, and never will, stabilize at the displayed voltage of 230vac. It will occasionally switch to 216vac or even continue to supply at 250vac (yes the UK generated supply is that variable now (used to be surprisingly well regulated).Save your money, this item is either poorly described or (well you can supply the obvious missing word) but it IS NOT A Stabilizer.
Andrew –
No Earth – DO NOT USE! RETURN iT!!
DANGEROUS!!Adapters supplied do not connect earth pin, putting your life at risk if you use this as supplied.If you have one you should return it immediately.Shame as output voltage was 228V to 233V logged over 30minutes.
Amazon Kunde –
Gutes Gerät, leider passt es zu meinem Generator nicht,
lolo88450 –
Grace à cet appareil j’ai économisé de l’argent, les plombs ont sautés ,le fusible logé derrière le stabilisateur,je l’ai changé et c’est reparti, j’ai perdu 500 euros avant de l’avoir !!!
Genfry M. –
Funziona perfettamente
francisco santos martinez herrero –
magnifico estabilizador de 220 voltios, tengo varios instalados y van geniales.
Client d’Amazon –
Merci pour le livraison rapide et soigneusement.